Audio Technica AT-LP60 Turntable Demo
the ATL P 60 is a fully automatic belt
drive turntable designed to connect
directly to a stereo system powered
speakers or other analog audio input it
features a built-in switchable phono
preamp along with a factory installed
dual magnet cartridge with replaceable
stylus before you can begin using your
turntable it needs to be set up
carefully remove the turntable from the
and make certain that you have all of
the parts and accessories you should
have the turntable with attached dust
cover and pre-installed cartridge stylus
assembly a die-cast aluminum platter
with drive belt a slip mat 45rpm adapter
instruction manual and two stereo audio
adapter cables begin by installing the
platter and drive belt carefully place
the platter on the spindle and make
certain it is fully seated rotate the
platter by hand until the rectangular
opening with the red ribbon exposes the
brass motor pulley
the brass pulley is located in the upper
left hand corner of the turntable
opposite the tonearm do not confuse the
motor pulley with the white plastic post
located near the tonearm while holding
the platter steady remove the tape
securing the red ribbon to the platter
the red ribbon is used to install the
drive belt onto the motor pulley holding
both ends of the ribbon carefully slip
the belt over the motor pulley
once the belt is seated in the pulleys
groove carefully remove the ribbon and
verify that the belt is not twisted next
place the turntable slip mat on the
platter with the tonearm still fastened
to the tone armrest slowly rotate the
platter by hand ten times in a clockwise
direction this is to make certain that
the automatic mechanism is fully cycled
next remove the plastic ties securing
the tonearm and discard the tie while
holding the tonearm
remove the plastic stylus guard by
slowly pulling it forward being careful
not to damage the stylus with the
turntable assembled the power and audio
connections can be made connect the
power cord to a convenient AC outlet the
ATL P 60 provides both a traditional
phono output along with a built-in
magnetic photo preamp providing an RIAA
equalized line low
output this makes the turntable
compatible with traditional phono inputs
on amplifiers and receivers along with
augs or line level inputs unpowered
speakers amplifiers and computer analog
sound cards if your device has its own
RIAA magnetic photo preamp simply set
the selector switch on the rear of the
turntable to phono bypassing the
turntables internal preamp if you are
connecting to an augs
line level input powered speakers sound
bars or analog inputs on a computer
sound card place the selector switch in
the line position to use the turntables
internal photo preamp if necessary use
the included adapter cables to adapt the
RCA plugs on the turntable to fit the
connector on the audio device for more
information visit us on the web at WWE
Audio Technica AT-LP60 Turntable Specs
|Motor||DC Servo-Controlled Belt-Drive|
|Speeds||33 1/3, 45 rpm|
|Signal to Noise Ratio||>50 dB (DIN-B)|
Output: Bluetooth Specification Power Class 2
Range: Up to 30′ / 10 m with Line of Sight
Codecs: SBC, aptX
|Connectors||1 x Stereo RCA Phono / Line Pair (Switchable Preamplifier)|
|Gain||Phono Preamp: 36 dB Nominal, RIAA Equalized|
|Output Level||Phono: 2.5 mV Nominal at 1 kHz, 5 cm/sec|
Line: 150 mV Nominal at 1 kHz, 5 cm/sec
|Turntable Platter||Die-Cast Aluminum|
|Power Requirements||120 VAC, 60 Hz, 3 W|
|Dimensions (W x H x D)||14.15 x 3.84 x 14.7″ / 359.5 x 97.5 x 373.3 mm|
|Weight||Not Specified by Manufacturer|
Audio Technica AT-LP60 Turntables
Audio Technica AT-LP60 Turntable offers quality, affordable hi-tech hi-fi performance like no other. Transform your old 45 RPM and 33-1/3 records into a hi-fi, state-of-the-art audio equipment with the Audio Technica AT-LP60 Turntable. Audio Technica is an innovator in hi-tech audio equipment and tonearm designs. With its two-year warranty and easy compatibility with PC interface drive systems, it’s hard to believe this is an old phonograph.
The Audio Technica AT-LP60 Turntable comes equipped with its own Audio-technica Dual Magnet Phono cartridge along with a replaceable tonearm. To eliminate tonal inconsistencies and improve consistency, a high performance bearing called the “flying lift” is included. The Audio Technica AT-LP60 Turntable also features a high performance braking system that utilizes ball bearings for maximum smoothness. In addition to its efficient drive function, the tonearm of the AT-LP 60 has an aluminum bearing that produces pinpoint accuracy and durability. The AT-LP also offers a heavy-duty two-way aluminum tonearm with a high precision dual rotating drum. The high-precision, pre-tuned, dual locking tonearm eliminates mechanical grinding and offers smooth tracking throughout its complete range of frequencies.
Audio Technica AT-LP60 Turntable also features built in signal conditioning with built in equalizer. With built in signal conditioning, users need not concern themselves with any problems associated with power supply. In addition, the AT-LP60 Turntable offers user friendly controls which eliminate the need for complex setup. All controls are easily user programmable and a safety lock is provided to assure maximum protection from damage. A conveniently placed safety lock allows safe operation of the AT-LP60 Turntables regardless of the positioning of the speakers.
Built in speakers, also called “line-ins”, allow users to connect their personal stereo system or their head units via the audio system output on the front of the AT-LP60. The on-board sound processor controls all functions such as volume, tuning, balance and bass. The start button starts the process of recording and other controls allow users to navigate through the tracks. An “Eject” button is provided for convenience in removing the turntables without disconnecting the cables from the wall or floor stand.
Like most other AT-Ps, the AT-LP60 has two basic models, each with a differing number of drive motors. The AT-LP-60S model has a built in phaser/tone controller for additional tonal options. The AT-LP-60M model incorporates an internal amp and includes two speakers. With all the different setup options, there is certainly an AT-LP60 to meet any user’s needs. Most consumer reviews have indicated that the Audio Technica AT-LP60 with its tonal options and built in phaser/tone controller offers a rich, natural sound quality.
Many audiophiles will find it difficult to choose between the Audio Technica AT-LP60 turntables because they all offer similar features. However, they all perform very well thanks to their high quality engineering and tonal options. The internal pre-amp within the AT-LP60 allows you to operate your turntables at maximum efficiency while maintaining high levels of sound quality. In addition, most models come with an audio interface that connects the output of the toner or phaser to the input of the internal pre-amp.
Audio Technica AT-LP60 Turntable FAQ
Audio-Technica AT-LP60 stereo turntable offers you the best of old and new worlds in high-performance, hi-tech, hi-res audio. The Audio-Technica AT-LP60 stereo turntable is designed for durability, precision and performance, delivering unsurpassed performance for your records and other audio media. Its state-of-the-art motorized tonearm is capable of spinning at a higher speed than its predecessors, which allows it to run at its true speed, even when not in use. Its exclusive Audio-Technica Dual Magnet tonearm eliminates mechanical noise in low frequencies, allowing the tonearm to deliver true musicality. The tonearm also incorporates a shock-absorbing pad to eliminate the vibration that is common from using the tonearm when it is not functioning optimally.
This Audio-Technica AT-LP60 stereo turntable comes with two built-in phono preamp kits: RCA Connect and Alpine. These cables are incorporated in the design of the unit and are designed to meet the requirements of today’s professional recording studios. You can connect your audio equipment directly to the AT-LP60 stereo by using the supplied RCA cables; you do not need an additional amp. The built-in RCA output allows you to send the stereo audio signal to any external sound device that will support RCA connections.
A Bluetooth adapter is also included as a part of the Audio-Technica AT-LP60 stereo turntable. This allows you to play back your favorite audio files using your MP3 player or your own computer. You can use this Bluetooth adapter cable to connect the turntables remotely via a network. In this way, you don’t need to carry extra cables. There is also a built-in rechargeable battery that offers you hours of listening pleasure. It is also a fully automatic unit that does not require manual operation.
The Audio-Technica Wireless Turntable is the latest high tech hi-tech product to come from the Audio-Technica company. If you are looking for a simple and easy to operate hi-end hi-fi unit, then this is the best option for you. It is one of the most compact and lightweight home hi-fi units, that is also a very good sounding unit. The Audio-Technica Wireless Turntable comes with a built in battery that is rechargeable and has a USB interface as well.
There are many features on the Audio-Technica Wireless Turntable that makes it stand out from other Hi Fi turntables on the market. First of all, it has a direct digital signal processor that gives hi-fi sounds such as true stereo sound, true 7 inch waves, and a true narrow frequency response. It also has a built in audio mixer that lets you adjust the level of the recording according to your desired level of sound. Another feature is the built in audio-stage that allows the sound to be amplified or filtered according to the desired sound effect. This is extremely helpful in creating any kind of music from a variety of genres.
The Audio-Technica Wireless Turntable also has an astounding list of accessories including an audio-rower, phono preamp, line input adapter, L EQ panel, phonic record button, audio output splitter, USB interface for the iPod, and a direct control adapter. Many users have commented that this turntable has a large LCD display that can be used as a display to check how the record is progressing. It is also said that if you connect the audio output connector to your computer via the USB port, that it will allow you to hear the sound through your headphones, unlike other models that require you to plug the device into a PCI slot. However, the latest models of the Wireless-Turntable by Audio-Technica include an external speakers connection that lets you plug in external speakers to get the real rock sound effect.
There’s no doubt that Audio-Technica is a very reliable brand when it comes to mixers, recorders and other audio equipment. The company has spent quite some time and money in research and development, and as a result, they have created some of the best mixing equipment around today. They have several models with different specifications and different functions, all depending on what you need it for, but still, they have created a product that has become the standard for professional audio engineers and DJs. This is especially true since they released their Bluetooth version of their popular Traktor series. Audio-Technica Bluetooth turntables are becoming more popular as the technology changes, as more people realize how well built and reliable they are.
If you’re looking for a high-quality Bluetooth mixer, one with several features including an anti-forward bias, phase shifting, and an excellent sound reproduction, you might want to check out the Audio-Technica Bluetooth Turntable. The audio quality alone is worth every penny, but the built-in Wi-Fi capability is a huge plus. You can connect your Audio-Technica Bluetooth turntable directly to your laptop or PC for a hassle-free, wire-free way to enjoy your favorite tunes on the go. No more searching for a speaker or headphones or trying to figure out how to hook them up – just bring your turntables!
Many professional DJs and music producers use Audio-Technica products in their own studio or home, as they are one of the best mixers and recorders available. The build quality is second to none, and this is evident with the many accessories that Audio-Technica offers. You’ll need a high-quality set of headphones or a set of audio cables in order to take full advantage of your unit, but other than that, these units are very easy to operate and the build quality is great. Don’t let the name limit your choices – Audio-Technica makes a ton of different models that will meet your needs.
Last update on 2021-08-25 / Disclaimer: as an Amazon Associate I earn from qualifying purchases.